Re: [oopic] Re: Motor Alternate Power Source

If you plug your motor (servo) battery pack into the +SP and GND pins
and leave the S1 to S4 jumpers in the "down" position to use the IO
regulator you will have a good 5V power supply on the power lines to
your servo connection. The optional regulator is not loaded (that would
be your job should you so desire to do it) so you won't get any voltage
when you have that jumper set.

DLC

jon_mark_go wrote:
> So I'm using a brand new OOPic... I hooked up the servo power
> properly, tested it on my multimeter first. The ends of the plugs read
> properly. But the motor lines I'm using are only getting .1V when the
> jumpers are set to use the alternate servo power. The rest of the
> OOPic is getting the proper +5 and so do the jumpered lines when the
> jumpers are normal.
>
>
> ------------------------------------
>
> Yahoo! Groups Links
>
>
>
>
>
>

--
------------------------------------------------------
Dennis Clark ooPIC Tech Support
www.oopic.com
------------------------------------------------------

------------------------------------

Yahoo! Groups Links

<*> To visit your group on the web, go to:

http://groups.yahoo.com/group/oopic/

<*> Your email settings:
Individual Email | Traditional

<*> To change settings online go to:

http://groups.yahoo.com/group/oopic/join

(Yahoo! ID required)

<*> To change settings via email:
mailto:oopic-digest@yahoogroups.com
mailto:oopic-fullfeatured@yahoogroups.com

<*> To unsubscribe from this group, send an email to:
oopic-unsubscribe@yahoogroups.com

<*> Your use of Yahoo! Groups is subject to:

http://docs.yahoo.com/info/terms/