>
> minghui1984 wrote:
> > SO anyone knows whats is wrong with the Iopack specifications? i
> > specified iopack 5 but it would not work. Other IOPacks also do
not
> > apply
> >
> > Minghui
> > --- In oopic@yahoogroups.com, "minghui1984" <minghui1984@> wrote:
> >
> >> Dim A As New oStepper
> >> Dim B As New oStepper
> >>
> >>
> >> Sub Main()
> >>
> >> A.IOPack = 1
> >> B.IOPack = 5
> >> A.Rate = 10
> >> B.Rate = 10
> >> A.Operate = 1
> >> B.Operate = 1
> >> Do
> >> A.Distance = 100
> >> B.Distance = 30
> >> Wait Until A.NonZero = 0
> >> Wait Until B.NonZero = 0
> >> ooPIC.Delay = 1000
> >> A.Distance = -100
> >> B.Distance = -30
> >> Wait Until A.NonZero = 0
> >> Wait Until B.NonZero = 0
> >> ooPIC.Delay = 1000
> >> Loop
> >>
> >> End Sub
> >>
> >>
> Minghui
>
> I have just checked your code on my Oopic B 2.2+ chip on a S board
and
> it is working as expected.
> Have you checked the actual outputs of Pack1 and pack2 with a meter
or a
> scope?
> If you are reading a pulsed output (5 volts) on your Oopic on the
> relative Pack outputs, then your problem lies in the wiring to or
from
> your Motor Driver hardware.
>
> Ian
>
I have checked the outputs for pack 1 and its working, but for the
pins on pack 5 its not.... i measured using a multimeter, there is no
pulse from the pin 13-15 but there is one on pin 12 ... The pack 5
consists of pin 12-15
Minghui
------------------------------------
Yahoo! Groups Links
<*> To visit your group on the web, go to:
http://groups.yahoo.com/group/oopic/
<*> Your email settings:
Individual Email | Traditional
<*> To change settings online go to:
http://groups.yahoo.com/group/oopic/join
(Yahoo! ID required)
<*> To change settings via email:
mailto:oopic-digest@yahoogroups.com
mailto:oopic-fullfeatured@yahoogroups.com
<*> To unsubscribe from this group, send an email to:
oopic-unsubscribe@yahoogroups.com
<*> Your use of Yahoo! Groups is subject to:
No comments:
Post a Comment