You old hamburger! Write me off list. Yes, it is the same project but OOpic will only be
used for one simple part of the bot now. A lot has changed. Everything seems to be
working so it must be the code. The motor turns but is ignoring the opto sensors. Tested
those and they're working. My next step was to try a sample program as u suggested. I'll
post the code I'm noodling.
Darrell
--- In oopic@yahoogroups.com, "theo570" <theo570@...> wrote:
>
>
> Darrell,
>
> If you are sure it is a code issue ie all connections have been checked
> as well as logic and motor power then the first thing to do is post your
> code here for us to see.
>
> If this is the project I assisted you with several years ago, I may
> still have source code on my PC.
>
> A test you could perform would be to open a new code window and launch
> the Sample program for the oDCMotorMGD. Alter the code to reflect your
> pinouts etc.. and compile. If this is on the project I think it is
> PLEASE break out a floor jack and get that thing off the ground. It
> would really suck to have a several hundred pound robot on the loose in
> the house...
>
> Good Luck.
>
> Ted Macy
> Savage Innovations
> www.oobug.com <http://www.oobug.com> The next revolution in robotics...
>
>
> --- In oopic@yahoogroups.com, "Darrell" <videogrfx@> wrote:
> >
> > Hi,
> > It's been a while since I've used an OOPic so forgive me. I'm using
> the OOPic to run a DC
> > motor via the Magnevation dual control board. The code I'm using
> worked last time I used
> > this board. (a year ago at least) Now it's not. The motor does a small
> step each time I hit the
> > re-set on the OOPic. After testing and confirming the OOPic is working
> and has power etc. I
> > was wondering if someone could give me a clue what to check next. The
> mag board seems
> > okay and I've never had an issue with one before. I'll recompile the
> code again next to see if
> > that helps. Thanks!
> > D.
> >
>
>
>
>
> [Non-text portions of this message have been removed]
>
------------------------------------
Yahoo! Groups Links
<*> To visit your group on the web, go to:
http://groups.yahoo.com/group/oopic/
<*> Your email settings:
Individual Email | Traditional
<*> To change settings online go to:
http://groups.yahoo.com/group/oopic/join
(Yahoo! ID required)
<*> To change settings via email:
mailto:oopic-digest@yahoogroups.com
mailto:oopic-fullfeatured@yahoogroups.com
<*> To unsubscribe from this group, send an email to:
oopic-unsubscribe@yahoogroups.com
<*> Your use of Yahoo! Groups is subject to:
No comments:
Post a Comment