Re: [oopic] OOPic-R and Parallax H-bridge

Can you provide a spec sheet? Your specs don't sound right to me.

DLC

kevsl294@hotmail.com wrote:
> I am trying to interface and OOpic-R and a Parallax H-bridge to drive a motor. I have the motor controller pulse and ground lines connected to pins 17 (pulse) and GND on the H-bride connector strip on the OOPic. The H-bridge Requires 9.2khz to operate and I wasn't sure if the OOPic can handle that frequency. It need output a 2.0ms pulse at 9.2khz. Is this possible to do with the OOPic-R.
>
> Thanks,
> Kev1814
>
> ------------------------------------
>
> Yahoo! Groups Links
>
>
>
>
>
>

--
------------------------------------------------------
Dennis Clark ooPIC Tech Support
www.oopic.com
------------------------------------------------------

------------------------------------

Yahoo! Groups Links

<*> To visit your group on the web, go to:

http://groups.yahoo.com/group/oopic/

<*> Your email settings:
Individual Email | Traditional

<*> To change settings online go to:

http://groups.yahoo.com/group/oopic/join

(Yahoo! ID required)

<*> To change settings via email:
mailto:oopic-digest@yahoogroups.com
mailto:oopic-fullfeatured@yahoogroups.com

<*> To unsubscribe from this group, send an email to:
oopic-unsubscribe@yahoogroups.com

<*> Your use of Yahoo! Groups is subject to:

http://docs.yahoo.com/info/terms/