I've sent this e-mail to roguerobotics.com but I guess I can post it
here as well.
------------------
Hello,
I've recently purchased Rogue ATR ERS Robot Kit for a
research purpose. I've assembled everything and
initially it worked fine with pre-loaded program which
was to move forward, alternatively turn, and move
backward when I press green, yellow, red buttons.
The problem is that whenever I try to load the
program, I need to do ESTOP jump every single time,
which is very frustrating cause even it takes several
trials to get it. Second, when I load the program
given on the website or the manual, the sample
programs, none of them seems to be working.
And lastly, my OOBoard seems little different from the
manual. Mine does not have Network I2C Connector, nor
SIMMBus pins. Since I need to get this working ASAP
for my research, I was wondering what the solution
would be. I just ordered this last week, and got it
two days ago through school. Is the replacement an
option?
Thank you.
Kyunghwan Choi
Carnegie Mellon University
Carnegie Institute of Technology - Engineering
M.S. ECE / CS
-------
I'm not sure if it's a compiler problem or if there is a problem with
the board itself. I hope they give me an replacement for the board
since I bought this last week.
Thank you very much for your help!
Yahoo! Groups Links
<*> To visit your group on the web, go to:
http://groups.yahoo.com/group/oopic/
<*> Your email settings:
Individual Email | Traditional
<*> To change settings online go to:
http://groups.yahoo.com/group/oopic/join
(Yahoo! ID required)
<*> To change settings via email:
mailto:oopic-digest@yahoogroups.com
mailto:oopic-fullfeatured@yahoogroups.com
<*> To unsubscribe from this group, send an email to:
oopic-unsubscribe@yahoogroups.com
<*> Your use of Yahoo! Groups is subject to:
No comments:
Post a Comment