[oopic] Trouble with IDE V6 and using parallel cable

I bought a OOPic ver B.1.0 a few years back and had no trouble using
it for a while. I had to shelf it for a few years and now that I am
trying to use it again I am having troubles configuring the OOPic IDE
to use a parallel port to program it. I am able to manually set the
port to 378 Hex and do a "find delay" ok. But when I try to do "find
parallel cable" or save the manual settings I get an error box saying
"Internal Error in PortInp of I2CFuncs." I have googled the error
message and also searched this group and could not find any answers.

I am using WinXP and have made sure the port is turned on in the BIOS.
I have also removed and reinstalled the LPT port in WinXP settings.
I also tried using OOPic IDE v5 and V6. IDE v5 will just crash with
no error box when I try to setup the parallel port.

Thanks for any help.

Jason

------------------------------------

Yahoo! Groups Links

<*> To visit your group on the web, go to:

http://groups.yahoo.com/group/oopic/

<*> Your email settings:
Individual Email | Traditional

<*> To change settings online go to:

http://groups.yahoo.com/group/oopic/join

(Yahoo! ID required)

<*> To change settings via email:
mailto:oopic-digest@yahoogroups.com
mailto:oopic-fullfeatured@yahoogroups.com

<*> To unsubscribe from this group, send an email to:
oopic-unsubscribe@yahoogroups.com

<*> Your use of Yahoo! Groups is subject to:

http://docs.yahoo.com/info/terms/