Re: [oopic] Trouble with PC communicating with OOPIC-R

What ooPIC are you using? If it is an ooPIC R or ooPIC C board then you
can use straight through DB9 cables. If you are using an ooPIC S board
then you will need the RS232 level converter in there to communicate
with the serial port to the PC.

DLC

Larry M. Leitch wrote:
> Hi Folks,
>
> I keep getting the "Cable Not Found" message when I try to connect to
> the OOPIC to program it.
>
> Do I need a Null-Modem? I think the answer is NO.
>
> Do I need an RS-232 to TTL Converter? I think the answer is YES and I
> use one (a UTEK)
>
> The firmware is C.1.1+. As far as I can tell, the cables are good; they
> are from Radio Shack and not home made.
>
> Thanks
>
> Larry
>
>
>
>
> Yahoo! Groups Links
>
>
>

--
------------------------------------------------------
Dennis Clark ooPIC Tech Support
www.oopic.com
------------------------------------------------------

Yahoo! Groups Links

<*> To visit your group on the web, go to:

http://groups.yahoo.com/group/oopic/

<*> Your email settings:
Individual Email | Traditional

<*> To change settings online go to:

http://groups.yahoo.com/group/oopic/join

(Yahoo! ID required)

<*> To change settings via email:
mailto:oopic-digest@yahoogroups.com
mailto:oopic-fullfeatured@yahoogroups.com

<*> To unsubscribe from this group, send an email to:
oopic-unsubscribe@yahoogroups.com

<*> Your use of Yahoo! Groups is subject to:

http://docs.yahoo.com/info/terms/