[oopic] Re: OOPic-R board problem

I test the voltage between PIN 1 & 8 of the EPROM and it measures at
5V. That means the small regulator is working. I also try
the "cosmic wedgie" recovery and it does not help. Then, I use
another OOPIC-R board and program the EPROM successfully. But puttig
it back on the problem OOPIC-R board has no response. The EAC light
is not ON at all. Is the board defective?

--- In oopic@yahoogroups.com, <dennis.clark@...> wrote:
>
> first, try the"cosmic wedgie" recovery. Let us know if that works.
>
> DLC
>
>
> ooPIC Tech Support
>
> -----Original Message-----
>
> From: "robot8868" <robot8868@...>
> Subj: [oopic] OOPic-R board problem
> Date: Thu Oct 18, 2007 11:24 pm
> Size: 918 bytes
> To: oopic@yahoogroups.com
>
> I have an OOPic-R board with firmware C.1.1+. After applying the
power
> to the board, the power good LED does NOT light up. Connect
through RS-
> 232 with PC does not show any response. But pushing the 3 little
> buttons on the board do light up the LED on top of it. Is the
board
> defective? How I can check if the OOPic is working ok?
>
>
>
>
> Yahoo! Groups Links
>

Yahoo! Groups Links

<*> To visit your group on the web, go to:

http://groups.yahoo.com/group/oopic/

<*> Your email settings:
Individual Email | Traditional

<*> To change settings online go to:

http://groups.yahoo.com/group/oopic/join

(Yahoo! ID required)

<*> To change settings via email:
mailto:oopic-digest@yahoogroups.com
mailto:oopic-fullfeatured@yahoogroups.com

<*> To unsubscribe from this group, send an email to:
oopic-unsubscribe@yahoogroups.com

<*> Your use of Yahoo! Groups is subject to:

http://docs.yahoo.com/info/terms/