[oopic] Re: Using the RST pin on oobot 4o-II

--- In oopic@yahoogroups.com, "jporterwbtcorp" <jporter@...> wrote:
>
> Does anyone know how to get an OObot 40-II do a reset other than
> pushing that tiny little button on the board? I am hitting the RST
pin
> with a logic high but nothing seems to happen.
>
> John
>

If you check the schematic, or use a voltmeter, you'll see that the
reset switch pulls pin 1 of the oopic chip to "ground".

If you want to do resets from an external signal, you should tap onto
the reset switch, rather than going straight to pin 1, since there is
a small resistor in series which will help protect the pin from
noise, bad signals, etc.

- dan michaels
www.oricomtech.com
=====================

Yahoo! Groups Links

<*> To visit your group on the web, go to:

http://groups.yahoo.com/group/oopic/

<*> Your email settings:
Individual Email | Traditional

<*> To change settings online go to:

http://groups.yahoo.com/group/oopic/join

(Yahoo! ID required)

<*> To change settings via email:
mailto:oopic-digest@yahoogroups.com
mailto:oopic-fullfeatured@yahoogroups.com

<*> To unsubscribe from this group, send an email to:
oopic-unsubscribe@yahoogroups.com

<*> Your use of Yahoo! Groups is subject to:

http://docs.yahoo.com/info/terms/