wrote:
>
> Its not a wedgie. I followed the wedgie removal steps exactly, and
> still got the same error message when I tried to download known
good
> code with the EEPROM removed. I also replaced the battery with a
> fresh one, even though I almost certain the old one was still good.
> Same result. After that, I went so far as to find a computer with
an
> RS232 connection and downloaded code just to make sure that I
could.
> It worked. No problems.
>
> What does the error message mean? I've seen examples on here where
> the message was expected v received x, but not one like mine.
>
> Any other suggestions?
>
Sounds like the USB-dongle to serial port drivers aren't loaded or
setup properly. Also, since it's an oopic-r I think you said, and
this uses a 0-5v serial port, there is an outside possibility it's
not compatible with the dongle.
Yahoo! Groups Links
<*> To visit your group on the web, go to:
http://groups.yahoo.com/group/oopic/
<*> Your email settings:
Individual Email | Traditional
<*> To change settings online go to:
http://groups.yahoo.com/group/oopic/join
(Yahoo! ID required)
<*> To change settings via email:
mailto:oopic-digest@yahoogroups.com
mailto:oopic-fullfeatured@yahoogroups.com
<*> To unsubscribe from this group, send an email to:
oopic-unsubscribe@yahoogroups.com
<*> Your use of Yahoo! Groups is subject to:
No comments:
Post a Comment