[oopic] New ooPic-R and Trouble Uploading File

I have recently received my new ooPic-R board and am having trouble
out of the gates with trying to program it. Let me run down some
facts about my current setup so that that diagnosing will take less time:

- The factory-loaded program is on there and properly runs on boot-up
- I am using a USB to Serial convertor cable
- I am pointing my software directly to the Serial Port (which is
even found by the IDE software)
- The error I get is the one referring to the "node" not being able
to be found. Upon pressing F5, there is a screen showing a progress
bar (that always stays on zero) and two to three seconds later,
another window pops up informing of the node problem and telling me to
try the EEPROM removal procedure (which I did).

Any suggestions at this point would be very helpful, as I'd like to
get something on there to see what this bad boy can do!

Thanks in advance,

Jonathan

------------------------------------

Yahoo! Groups Links

<*> To visit your group on the web, go to:
http://groups.yahoo.com/group/oopic/

<*> Your email settings:
Individual Email | Traditional

<*> To change settings online go to:
http://groups.yahoo.com/group/oopic/join
(Yahoo! ID required)

<*> To change settings via email:
mailto:oopic-digest@yahoogroups.com
mailto:oopic-fullfeatured@yahoogroups.com

<*> To unsubscribe from this group, send an email to:
oopic-unsubscribe@yahoogroups.com

<*> Your use of Yahoo! Groups is subject to:
http://docs.yahoo.com/info/terms/