[oopic] Re: OOPic B.2.2+'s

I make my own boards with RS232 using a ST232ACN which works great.
But I also have some other hardware on board for ethernet
communications. I use a Multiplexer to use one serial port with
several devices (RS232, RS485/422, as well as the TTL version). The
problem with the C's is that some of the code to setup the external
devices (mainly the Ethernet/IP co-processor) is not running
correctly or at all. That code works great on the B versions so I
will probably order some of those from below for $28 and it comes
with an EEPROM as well.

--- In oopic@yahoogroups.com, "rtstofer" <rstofer@...> wrote:
>
> --- In oopic@yahoogroups.com, "tinslwc" <tinslwc@> wrote:
> >
> > Are there any places that carry this firmware version for less
than
> > $29.99? That is what Savage is selling the C's for. I am having
> > problems with the C's. Some code (excluding events, I can work
around
> > those) will work fine on the B's but not on the C's. I cannot
figure
> > it out so I just want to replace my C's with B's.
> >
>
> In the 40 pin DIP version, you might get some here:
> http://www.junun.org/MarkIII/Info.jsp?item=29 or a controller (kit)
> here: http://www.junun.org/MarkIII/Info.jsp?item=28
>
> One nice thing about the Mark III controller is that it uses a real
> RS232 level shifter. The 40 pin header is compatible with the
OOPic S
> board.
>
> Richard
>

------------------------------------

Yahoo! Groups Links

<*> To visit your group on the web, go to:

http://groups.yahoo.com/group/oopic/

<*> Your email settings:
Individual Email | Traditional

<*> To change settings online go to:

http://groups.yahoo.com/group/oopic/join

(Yahoo! ID required)

<*> To change settings via email:
mailto:oopic-digest@yahoogroups.com
mailto:oopic-fullfeatured@yahoogroups.com

<*> To unsubscribe from this group, send an email to:
oopic-unsubscribe@yahoogroups.com

<*> Your use of Yahoo! Groups is subject to:

http://docs.yahoo.com/info/terms/