>
> Hello,
> I would like to know if it's possible to mak ethe oopic communicate
> with other controler(an arduino in my case).
Serial might not be your best choice but, if you can implement
hardware flow control on the arduino, it can be made to work.
I would try parallel: an 8 bit port managed by one end of the other.
SPI is another possibility as long as the OOPic can be the master.
> I surely can use it trought I2C. But can I set up the oopic to be
slave ?
No, the OOPic is always a master on the local I2C bus - the one with
the EEPROM. The OOPic will appear as a RAM to other devices.
Getting the proper address is an exercise for the reader.
> Or using the ddelink ?
Maybe; that uses an OOPic specific protocol. Grab the
OOPicI2CTools.zip file from the Files section and see if it helps.
> At least if I can't use the ddelink, can I use the ioline of ddelink
> to do something else ?
Yes
Richard
Yahoo! Groups Links
<*> To visit your group on the web, go to:
http://groups.yahoo.com/group/oopic/
<*> Your email settings:
Individual Email | Traditional
<*> To change settings online go to:
http://groups.yahoo.com/group/oopic/join
(Yahoo! ID required)
<*> To change settings via email:
mailto:oopic-digest@yahoogroups.com
mailto:oopic-fullfeatured@yahoogroups.com
<*> To unsubscribe from this group, send an email to:
oopic-unsubscribe@yahoogroups.com
<*> Your use of Yahoo! Groups is subject to:
No comments:
Post a Comment