Re: [oopic] Re: OOPic R Problem

If you compiled, but didn't download it would look like this. Please
give me a "blow-by-blow" account of every step that you took, compile,
build, download, and any messages that were given. What locale is your
Windows system using?

DLC

oscarhkw wrote:
> --- In oopic@yahoogroups.com, "rtstofer" <rstofer@...> wrote:
>
>> --- In oopic@yahoogroups.com, "oscarhkw" <oscarhkw@> wrote:
>>
>>> Hello All,
>>>
>>> I bought two OOPic R (firmware B2.2 +) for my research. However, I
>>> found that all boards cannot run the program properly. I used
>>>
> Windows
>
>>> XP and OOPic 5.01 compiler as a programming environment and
>>>
> followed
>
>>> the example:
>>>
>>> Dim LED as New ODio1
>>>
>>> Sub Main()
>>>
>>> OOPic.delay = 500
>>> LED.IOLine = 6
>>> LED.Direction = cvOutput
>>>
>>> Do
>>> LED =OOPic.Hz1
>>> Loop
>>>
>>> End Sub
>>>
>>> from the book called "Programming and customizing the OOPic
>>> Microcontroller" in order to test one of the boards but the
>>>
> yellow LED
>
>>> does not flash after the program being downloaded. I have tried
>>> antoher board. it also has this problem. Also, I did try "cosmic
>>> wedgie" recovery but it still doesn't work. How can I repair those
>>> OOPic boards
>>>
>>>
>> Which programming method did you use, parallel or serial cable? If
>> you used the serial cable and the device programmed successfully (no
>> errors from the IDE and you watched the download progress bar move
>> left to right) then the OOPic itself is working.
>>
>> With the parallel cable, programming will almost always succeed
>> because the cable programs the EEPROM while holding the OOPic in
>> reset. Successful programming of the EEPROM says nothing about the
>> state of the OOPic.
>>
>> Check the obvious things first: battery voltage, logic voltage (+5
>>
> on
>
>> pin 4 of either I2C connector (the white 5 pin connectors) relative
>>
> to
>
>> ground on pin 2. This is a different voltage regulator than the one
>> that supplies the outer two pins of the IO header. You might as
>>
> well
>
>> check that voltage as well - say adjacent to IOLine 1.
>>
>> You did install Port95NT.exe before installing the IDE, right?
>> www.oopic.com/dloadp.html
>>
>> Richard
>>
>>
>
> I did install Port95NT.exe already. I tried both methods and no error
> message appeared but OOPic boards also cannot work properly.
>
>
>
>
> Yahoo! Groups Links
>
>
>
>

--
------------------------------------------------------
Dennis Clark ooPIC Tech Support
www.oopic.com
------------------------------------------------------

Yahoo! Groups Links

<*> To visit your group on the web, go to:

http://groups.yahoo.com/group/oopic/

<*> Your email settings:
Individual Email | Traditional

<*> To change settings online go to:

http://groups.yahoo.com/group/oopic/join

(Yahoo! ID required)

<*> To change settings via email:
mailto:oopic-digest@yahoogroups.com
mailto:oopic-fullfeatured@yahoogroups.com

<*> To unsubscribe from this group, send an email to:
oopic-unsubscribe@yahoogroups.com

<*> Your use of Yahoo! Groups is subject to:

http://docs.yahoo.com/info/terms/