[oopic] Re: Serial To LCD messing up

--- In oopic@yahoogroups.com, Andrew Porrett <slicerwizard@...> wrote:
>
> At 03:44 PM 6/16/2008, ef721 wrote:
> >Even when I output the data to serial it repeats. What am I doing
> >wrong and how do I clear that old data?
>
> Are you saying that the LCD.Clear command isn't working?
>
> The OOPic manual says that command only works on a Scott Edwards LCD
> module. If you're using a different module, you have to use its
> clear command (or you could write a bunch of blanks)
>
> Is this what your problem is?
>
>
> ...Andy
>

Thanks for the reply.

My problem is as follows, even in this case without an LCD it messes up:
I send the number "1" from the serial port to the ooPIC
The ooPIC reads it and sends it right back out to the serial port,
where it is read by terminal. Up to here everything is working fine
Then when I send another number , lets say "2" , the ooPIC sends out
the serial port the old number (1) AND the new number (2).
So on the terminal window I would see the arrangement "1 1 2".

Why does it store the old number in the ooPIC and how can I clear it,
or perhaps there is something else I could do?

Thanks for helping out here.

------------------------------------

Yahoo! Groups Links

<*> To visit your group on the web, go to:

http://groups.yahoo.com/group/oopic/

<*> Your email settings:
Individual Email | Traditional

<*> To change settings online go to:

http://groups.yahoo.com/group/oopic/join

(Yahoo! ID required)

<*> To change settings via email:
mailto:oopic-digest@yahoogroups.com
mailto:oopic-fullfeatured@yahoogroups.com

<*> To unsubscribe from this group, send an email to:
oopic-unsubscribe@yahoogroups.com

<*> Your use of Yahoo! Groups is subject to:

http://docs.yahoo.com/info/terms/