>
> okay lets ignore the previous code and work at one problem at a time.
> Say i want to replicate code like the example i posted in the first
> part of my post. With start signal, address,length,command,stop. Can i
> just use simple layout like
> i2c.value=ff *what variable type goes here? should i send it as 255?
> i2c.value=00 *FF 00 is the start sequence for the RFID module it seem
> i2c.value=42 *developer for i2c stated address is 42 but with 7bit
> addressing mode you shifted right so 84 for write and 85 for read
> i2c.value=81 *get firmware command
> i2c.value=82 *checksum
>
> places where it confuse me is PicMicro state the address of the slave
> during the transmission sequence. OOpic seem to do this in the
i2c.node
>
You really need to post a link to the datasheet for your sensor so we
can see what you are trying to do. On the OOPic, you don't deal with
the concepts of start and stop. When you write to I2C, the OOPic
handles all of that.
So, just send the values you need. That checksum is going to be a
bother.
You can send 255 instead of 0xff
Richard
Yahoo! Groups Links
<*> To visit your group on the web, go to:
http://groups.yahoo.com/group/oopic/
<*> Your email settings:
Individual Email | Traditional
<*> To change settings online go to:
http://groups.yahoo.com/group/oopic/join
(Yahoo! ID required)
<*> To change settings via email:
mailto:oopic-digest@yahoogroups.com
mailto:oopic-fullfeatured@yahoogroups.com
<*> To unsubscribe from this group, send an email to:
oopic-unsubscribe@yahoogroups.com
<*> Your use of Yahoo! Groups is subject to:
No comments:
Post a Comment