>
> c 1.1 +, v 6.1.1 compiler, oopic C carrier board (IMG D-9 94v-0
0442)
> My whole attempt with that program was to actually see the event
program
> work. I have not accomplished that yet. I tried changing the delay
to 500 as
> you suggested, the same results. I tried the program that you sent
in your
> response and again with no wires attached to my board it still
does the same
> thing the red led never comes on. the green led blinks on about a
5 second
> interval and eventually goes out and stays our, without running
the subroutine.
> so far the controller has worked as expected except for
events. It runs
> my robot just fine if I replace the events with To Do loops it
works. Is it
> possible that the events have quit working on this
board/compiler/chip and
> every thing else works?
I suppose anything is possible. I ran the code with just that one
change on V6 and a B2.2+ chip.
If you are still having those high voltages, there is a good chance
your chip is toast.
Richard
Yahoo! Groups Links
<*> To visit your group on the web, go to:
http://groups.yahoo.com/group/oopic/
<*> Your email settings:
Individual Email | Traditional
<*> To change settings online go to:
http://groups.yahoo.com/group/oopic/join
(Yahoo! ID required)
<*> To change settings via email:
mailto:oopic-digest@yahoogroups.com
mailto:oopic-fullfeatured@yahoogroups.com
<*> To unsubscribe from this group, send an email to:
oopic-unsubscribe@yahoogroups.com
<*> Your use of Yahoo! Groups is subject to:
No comments:
Post a Comment