[oopic] SerLCD1 (Kronos Robotics) With OOPic-R

Hello,

I recently purchased a 4x20 Mark III parallel LCD (
http://www.junun.org/MarkIII/Info.jsp?item=36 ), along with a Kronos
Robotics Serial LCD Deluxe Piggy Back ( http://tinyurl.com/2n68jb ),
the latter of which allows a microcontroller to control the LCD
through a serial interface. I am planning on connecting the Piggy
Back to the designated Serial LCD I/O pins (line 16, +5v, and Gnd) on
my OOPic-R. Does anyone happen to know what OOPic object I should use
to control my setup? Could I use oLCDSE and change the baud rate to
9600 (that of the SerLCD1 chip)? Or should I use one of the various
oSerial objects? Also, is the Serial LCD I/O connector the best place
to be connecting the Piggy Back to my board?

Thanks for your help,

Jason Quint

Yahoo! Groups Links

<*> To visit your group on the web, go to:

http://groups.yahoo.com/group/oopic/

<*> Your email settings:
Individual Email | Traditional

<*> To change settings online go to:

http://groups.yahoo.com/group/oopic/join

(Yahoo! ID required)

<*> To change settings via email:
mailto:oopic-digest@yahoogroups.com
mailto:oopic-fullfeatured@yahoogroups.com

<*> To unsubscribe from this group, send an email to:
oopic-unsubscribe@yahoogroups.com

<*> Your use of Yahoo! Groups is subject to:

http://docs.yahoo.com/info/terms/