[oopic] Re: Serial Programming

--- In oopic@yahoogroups.com, will shryock <rock133_2000@...> wrote:
>
> Richard,
>
> Thanks for the information, That is great. Now, what pins on the
Pololu serial adapter would goto the programming conn. on the OOpic S
board. I can take a good guess on the 5 volt and gnd but as far as the
communication lines I am alittle confused. Thanks again.
>
> Will Shryock
>

From the Pololu documentation, TX is and output and Rx is an input.
From the OOPic documentation, pin 37 is Xmit output and pin 39 is Recv
input.

So, Pololu TX goes to pin 39, RX goes to 37.

Richard

Yahoo! Groups Links

<*> To visit your group on the web, go to:

http://groups.yahoo.com/group/oopic/

<*> Your email settings:
Individual Email | Traditional

<*> To change settings online go to:

http://groups.yahoo.com/group/oopic/join

(Yahoo! ID required)

<*> To change settings via email:
mailto:oopic-digest@yahoogroups.com
mailto:oopic-fullfeatured@yahoogroups.com

<*> To unsubscribe from this group, send an email to:
oopic-unsubscribe@yahoogroups.com

<*> Your use of Yahoo! Groups is subject to:

http://docs.yahoo.com/info/terms/