Re: [oopic] Trouble with new OOpic

The obvious check is to make sure that you have power at the LED, then
that the LED is good. After that, make sure that you have the correct
pin chosen - Often we will confuse the IOLine with the I/O pin number.
If you have 5V on the board and everything else checks out good then you
need to consider if the ooPIC PIC chip has been damaged. They are
pretty tough, so trying another IOLine might do the trick. Can you post
your code?

DLC

andy braham wrote:
> Hello all,
> My son and I are working on a school project using a OOPic II. We
> are trying to make sure that the OOPic is working so we tried loading
> a sample of the oLED object and hooked up a LED just to make sure that
> everything was working ok but it is not. We do not get any errors when
> downloading and can read the info from the eprom. I checked the ioline
> with a volt meeter and there is no voltage so i tried changing the
> ioline and still get the same result.
> I looked up the troubleshooting on the website and everything looks
> ok. i setup the programming cable again and the program finds it and
> set the delay.
> I have experiance with working with OOPics and have never seen this
> and i am totaly lost why this is happening any ideas?
>
> Thanks
> Andy
>
>
>
>
> Yahoo! Groups Links
>
>
>
>
>

--
------------------------------------------------------
Dennis Clark ooPIC Tech Support
www.oopic.com
------------------------------------------------------

Yahoo! Groups Links

<*> To visit your group on the web, go to:

http://groups.yahoo.com/group/oopic/

<*> Your email settings:
Individual Email | Traditional

<*> To change settings online go to:

http://groups.yahoo.com/group/oopic/join

(Yahoo! ID required)

<*> To change settings via email:
mailto:oopic-digest@yahoogroups.com
mailto:oopic-fullfeatured@yahoogroups.com

<*> To unsubscribe from this group, send an email to:
oopic-unsubscribe@yahoogroups.com

<*> Your use of Yahoo! Groups is subject to:

http://docs.yahoo.com/info/terms/