it was nothing about connections.
--- In oopic@yahoogroups.com, <dennis.clark@...> wrote:
>
> Battery? An oft overlooked culprit.
>
> DLC
>
> ooPIC Tech Support
>
> -----Original Message-----
>
> From: "chngedik" <mcgedik@...>
> Subj: [oopic] need technical support, anyone can help?
> Date: Fri Jan 4, 2008 1:57 pm
> Size: 1K
> To: oopic@yahoogroups.com
>
> hi guys, ladies;
>
> i have been working on a graduating project and i decided to use
> oopic. few tries later, there was an error occured;
> -------------
> the fallowing was detected while establishing I2C communications
>
> the I2C bus clock status reported a logic state 1, when a logic state
> of 0 expected this could be caused any of the fallowing;
>
> A. the programming port is not configured correctly
> B. the programming cable was not attached to the PC (it was)
> C. the programming cable's I2C clock line is not properly connected
> D. the programming cable's I2C clock status line is not properly
connected
> E. the I2C clock line is shorted to +5 volts on the oopic or in the
cable.
> F. the I2C clock status line is shorted to +5 volts in the cable.
> -------------------
>
> i tried the cable, it was ok. i controlled it's connections. also
> remade a new one still the same error.
>
> i tried the troubleshooting page on the manuel. the oopic passed all
> the tests also.
>
> i tried the 10k on the resistance near to eeprom for capacitances.
>
> i don't know what to do next. i need some advices.
> thanks for your helps.
>
> cihan.
>
>
>
>
>
>
> Yahoo! Groups Links
>
Yahoo! Groups Links
<*> To visit your group on the web, go to:
http://groups.yahoo.com/group/oopic/
<*> Your email settings:
Individual Email | Traditional
<*> To change settings online go to:
http://groups.yahoo.com/group/oopic/join
(Yahoo! ID required)
<*> To change settings via email:
mailto:oopic-digest@yahoogroups.com
mailto:oopic-fullfeatured@yahoogroups.com
<*> To unsubscribe from this group, send an email to:
oopic-unsubscribe@yahoogroups.com
<*> Your use of Yahoo! Groups is subject to:
No comments:
Post a Comment